Facts About Generators
GeneratorsDirectoryCompareRepairEnginesControllersPartsManufacturersGuides
Search models or part #
Home›Repair guides›Generac›Starting

Generac Impact-36G / NP-36G — Starting

Operation · engine

For the Generac Impact-36G / NP-36G, from the Generac owner's manual.

Applies to: Generac GN-220 engine

Before you start

  • Holding switch longer than 15 seconds may damage the starter motor

Procedure

  1. Turn OFF electrical loads using main line circuit breaker or transfer switch
  2. Hold the start/stop switch at START; release when engine starts
  3. If engine does not start after 15 seconds cranking, release and try again
  4. Let engine run at no-load for a few minutes to stabilize and warm up
  5. Turn ON electrical loads

Source: Generac owner's manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.

More Generac repair guides →