Generac Impact-36G / NP-36G — Initial Start after Installation
Installation · Generator set
For the Generac Impact-36G / NP-36G, from the Generac owner's manual.
Applies to: Generac GN-220 engine
Before you start
- Correct any leakage immediately before proceeding
Procedure
- Check engine crankcase oil level and fill to FULL mark with recommended oil.
- Check fuel supply; purge and leak test fuel lines and open all shutoff valves.
- Turn off all electrical loads at generator main circuit breaker.
- Prime fuel lines using the Primer Switch, then start the engine.
- Let engine warm up about five minutes.
- Inspect for fuel, oil and exhaust system leaks; correct any leakage immediately.
- Apply electrical loads and run at least 30 minutes with load applied.
- Turn off loads, let unit run at no-load briefly, then shut down.
Specs & values
- Apply loads equal to about 75-100 Amazon eBay FridayParts $2655.00% of rated wattage/amperage capacity for testing
Source: Generac owner's manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.