Generac Impact-36G / NP-36G — Adjust Throttle Linkage
Adjustments · Electronic governor to carburetor linkage rod
For the Generac Impact-36G / NP-36G, from the Generac owner's manual.
Applies to: Generac GN-220 engine
Before you start
- Do not overbend the spring clip or the clip will lose its clamping force
Procedure
- Start generator, then shut it down right away.
- Observe throttle lever rotating counterclockwise as engine coasts to stop.
- Check gap of 0.003 inch (0.08-0.5mm) between stop tab and carburetor stop block.
- With pliers, lightly compress the spring clip on the carburetor lever arm.
- Slide linkage rod through clip and rotate throttle lever to set gap.
- Release spring clip to secure adjustment.
Tools required
- Pliers Amazon
Tool links are Amazon searches (affiliate links); manufacturer special tools may only be available from a dealer.
Specs & values
- Gap 0.003 inch (0.08-0.5mm)
Source: Generac owner's manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.