Facts About Generators
GeneratorsDirectoryCompareRepairEnginesControllersPartsManufacturersGuides
Search models or part #
Home›Repair guides›Generac›Prepare Fuel System/Engine for Storage

Generac GP3300 — Prepare Fuel System/Engine for Storage

Maintenance

For the Generac GP3300, from the Generac owner's manual.

Applies to: Generac GP3300

Before you start

  • Vision Loss. Eye protection is required to avoid spray from spark plug hole when cranking engine.

Procedure

  1. Loosen screw (A) and drain fuel from carburetor.
  2. Change engine oil.
  3. Remove spark plug.
  4. Pour tablespoon (5-10cc) of clean engine oil or spray a suitable fogging agent into cylinder.
  5. Pull starter recoil several times to distribute oil in cylinder.
  6. Install spark plug.
  7. Pull recoil slowly until resistance is felt to close valves; gently release recoil.

Specs & values

  • Fuel stabilizer treated fuel can be stored up to 24 months
  • Run engine 10-15 FridayParts $30.67 minutes to circulate stabilizer

Full service-parts list: Generac GP3300 →

Source: Generac owner's manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.

More Generac repair guides →