Generac G0072100 — Generator Electrical Connections
Installation · Electrical wiring enclosure
For the Generac G0072100, from the Generac service manual.
Applies to: Generac G0072100
Procedure
- Remove main AC / control wiring knockout plugs from back of generator.
- Install conduit and main AC and control wires between generator and transfer switch.
- Close unused hole with a NEMA 3R rated plug.
- Strip insulation and route sense wires through wire tie to sense wire terminal block.
- Route control wires through second wire tie to control wire terminal block.
- Tighten wire ties and clip excess length.
Tools required
Tool links are Amazon searches (affiliate links); manufacturer special tools may only be available from a dealer.
Full service-parts list: Generac G0072100 →
Source: Generac service manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.