Generac G0072100 — Fascia Installation

Installation

For the Generac G0072100, from the Generac service manual.

Applies to: Generac G0072100

Procedure

1. Screw four threaded black rubber bumpers into end pieces (two each).
2. Snap one end piece into one front/rear fascia piece; repeat for other two pieces.
3. Place both assemblies at generator base and fit rubber mounts into lifting holes.
4. Snap together the two remaining connection points.

Full service-parts list: Generac G0072100 →

Source: Generac service manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.

More Generac repair guides →