Generac — Adjusting Throttle Linkage
Adjustments · Electronic governor / carburetor throttle linkage
From a Generac owner's manual covering: IMPACT 36, IMPACT-34 plus, Impact-36 plus. Check it applies to your exact model before use.
Applies to: Generac Impact-36 plus, Generac GN-220 engine
Before you start
- Do not overbend the spring clip or the clip will lose its clamping force.
Procedure
- Start generator, then shut down right away; observe throttle lever rotate counterclockwise.
- Check for gap of 0.003 inch (0.08-0.5mm) between stop tab and stop block.
- With pliers, lightly compress spring clip on carburetor lever arm to slide linkage rod freely.
- Rotate throttle lever to set gap to 0.003 inch (0.08-0.5mm).
- Release spring clip to secure adjustment.
Tools required
- Pliers Amazon
Tool links are Amazon searches (affiliate links); manufacturer special tools may only be available from a dealer.
Specs & values
- Gap 0.003 inch (0.08-0.5mm)
Full service-parts list: Generac Impact-36 plus →
Source: Generac owner's manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.