Facts About Generators
GeneratorsDirectoryCompareRepairEnginesControllersPartsManufacturersGuides
Search models or part #
Home›Repair guides›Generac›Engine Start-up and Transfer

Generac 6.8L V-10 / V-10 6.8L — Engine Start-up and Transfer

Operation · Generator

For the Generac 6.8L V-10 / V-10 6.8L, from the Generac owner's manual.

Applies to: Generac V-10 6.8L, Generac V-type engine, Generac V-type 6.8L engine

Before you start

  • Do not crank the engine continuously for longer than 30 seconds.

Procedure

  1. Turn OFF or disconnect the utility power circuit to the transfer switch.
  2. Set the transfer handle to its UTILITY (NORMAL) position.
  3. Set the generator's main line circuit breaker to its OFF position.
  4. Start the generator.
  5. Let engine stabilize and warm up.
  6. Check all applicable instrument and gauge readings.
  7. Move the transfer switch manual handle to STANDBY position.
  8. Set the generator's main line circuit breaker to its ON position.

Full service-parts list: Generac V-10 6.8L →

Source: Generac owner's manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.

More Generac repair guides →