Generac 005213-0 — Intake Manifold Procedure
Repair & overhaul
For the Generac 005213-0, from the Generac owner's manual.
Applies to: Generac In Line engine
Procedure
- Clean and inspect the mounting surfaces of the intake manifold and the cylinder head; both must be clean and flat.
- Clean and lightly oil the manifold bolt/stud threads.
- Install a new lower intake manifold gasket.
- Position the lower intake manifold to the cylinder head.
- Install retaining bolts/studs finger tight.
- Tighten all bolts/studs to first pass 7-10 N-m (5-7 lb-ft) in sequence.
- Tighten all bolts/studs to final pass 26-38 N-m (19-28 lb-ft) in sequence.
Specs & values
- First pass 7-10 N-m (5-7 lb-ft)
- Final pass 26-38 N-m (19-28 lb-ft)
Source: Generac owner's manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.