Fischer Panda PMS 8 mini E-TEC / Panda PMS 8 mini E-TEC — Execution of an oil change
Maintenance · Engine oil circuit
For the Fischer Panda PMS 8 mini E-TEC / Panda PMS 8 mini E-TEC, from the Fischer Panda service manual.
Applies to: Icemaster GmbH (Fischer Panda) Panda PMS 8 mini E-TEC, Kubota Z482 engine
Parts for this job
Part numbers from the service-parts lists for Icemaster GmbH (Fischer Panda) Panda PMS 8 mini E-TEC, Kubota Z482 engine. Verify against your serial number before ordering; some links are affiliate links.
Procedure
- Open oil drain screw and drain oil into container.
- Close oil drain screw.
- Remove oil filter with oil filter strap.
- Coat new oil filter gasket with oil.
- Tighten oil filter by hand.
- Open oil filler neck and refill oil.
- Wait, then check oil level on dipstick; recommended 2/3.
Tools required
Tool links are Amazon searches (affiliate links); manufacturer special tools may only be available from a dealer.
Specs & values
- Oil capacity 2.1 l
- Oil level max marking; recommended 2/3
Full service-parts list: Icemaster GmbH (Fischer Panda) Panda PMS 8 mini E-TEC →, Kubota Z482 engine →
Source: Fischer Panda service manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.