Fischer Panda PMS 8 mini E-TEC / Panda PMS 8 mini E-TEC — Exchange of the V-belt for internal cooling water pump
Maintenance
For the Fischer Panda PMS 8 mini E-TEC / Panda PMS 8 mini E-TEC, from the Fischer Panda service manual.
Applies to: Icemaster GmbH (Fischer Panda) Panda PMS 8 mini E-TEC, Kubota Z482 engine
Parts for this job
- G3102-8832-0 Belt — Icemaster GmbH (Fischer Panda) Panda PMS 8 mini E-TEC Amazon eBay
Part numbers from the service-parts lists for Icemaster GmbH (Fischer Panda) Panda PMS 8 mini E-TEC, Kubota Z482 engine. Verify against your serial number before ordering; some links are affiliate links.
Procedure
- Loosen fixing screw above alternator.
- Loosen fixing screw below alternator only a little.
- Press alternator toward thermostat housing.
- Replace V-belt type XPZ 850.
- Pull alternator back to tension belt.
- Belt should deflect approx. 1 cm with thumb.
- Tighten fixing screws above and below alternator.
Specs & values
- V-belt type XPZ 850
- Deflection approx. 1 cm with thumb
Full service-parts list: Icemaster GmbH (Fischer Panda) Panda PMS 8 mini E-TEC →, Kubota Z482 engine →
Source: Fischer Panda service manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.