Fischer Panda PMS 8 mini E-TEC / Panda PMS 8 mini E-TEC — Exchange of the impeller
Maintenance · Raw water pump
For the Fischer Panda PMS 8 mini E-TEC / Panda PMS 8 mini E-TEC, from the Fischer Panda service manual.
Applies to: Icemaster GmbH (Fischer Panda) Panda PMS 8 mini E-TEC, Kubota Z482 engine
Procedure
- Close raw water stop cock.
- Remove raw water pump cover screws and cover.
- Pull impeller from shaft with multigrip pliers.
- Check impeller for damage; replace if necessary.
- Lubricate impeller with glycerin or silicone spray.
- Install impeller in correct position.
- Fit cover with new seal.
Tools required
- multigrip pliers Amazon
Tool links are Amazon searches (affiliate links); manufacturer special tools may only be available from a dealer.
Full service-parts list: Icemaster GmbH (Fischer Panda) Panda PMS 8 mini E-TEC →, Kubota Z482 engine →
Source: Fischer Panda service manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.