Fischer Panda PMS 8 mini E-TEC / Panda PMS 8 mini E-TEC — De-aerating the fuel system
Maintenance
For the Fischer Panda PMS 8 mini E-TEC / Panda PMS 8 mini E-TEC, from the Fischer Panda service manual.
Applies to: Icemaster GmbH (Fischer Panda) Panda PMS 8 mini E-TEC, Kubota Z482 engine
Procedure
- Switch 'Stand by' switch on control panel to ON.
- Push and hold fuel purge switch S2; electric fuel pump must run audibly.
- Run fuel pump 3 to 4 minutes.
- Open bleeding screw on fuel solenoid valve while still pressing switch.
- Place cloth under connection to catch fuel.
- Close bleeding screw when fuel runs without bubbles.
- Release switch and start unit with Run/Stop button.
- If no start, loosen injection nozzle pipe union and retry; tighten after start.
Tools required
- cloth or absorbent paper Amazon
Tool links are Amazon searches (affiliate links); manufacturer special tools may only be available from a dealer.
Full service-parts list: Icemaster GmbH (Fischer Panda) Panda PMS 8 mini E-TEC →, Kubota Z482 engine →
Source: Fischer Panda service manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.