Fischer Panda PMS 8 mini E-TEC / Panda PMS 8 mini E-TEC — De-aerating of the coolant circuit
Maintenance
For the Fischer Panda PMS 8 mini E-TEC / Panda PMS 8 mini E-TEC, from the Fischer Panda service manual.
Applies to: Icemaster GmbH (Fischer Panda) Panda PMS 8 mini E-TEC, Kubota Z482 engine
Before you start
- Do not open cooling water pump de-aerating screw while generator runs.
Procedure
- Stop generator before opening de-aerating points.
- Open de-aerating screw at cooling water pump.
- Open de-aerating screw at thermostat housing.
- Fill coolant at filler neck until level stops falling.
- Close filler cap and de-aerating screws.
- Start generator; repeat de-aeration several times.
- Check external expansion tank filled to max mark.
Full service-parts list: Icemaster GmbH (Fischer Panda) Panda PMS 8 mini E-TEC →, Kubota Z482 engine →
Source: Fischer Panda service manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.