Fischer Panda PMS 8 mini E-TEC / Panda PMS 8 mini E-TEC — Adjustment of the maximum upper speed
Adjustments · Actuator spindle
For the Fischer Panda PMS 8 mini E-TEC / Panda PMS 8 mini E-TEC, from the Fischer Panda service manual.
Applies to: Icemaster GmbH (Fischer Panda) Panda PMS 8 mini E-TEC, Kubota Z482 engine
Procedure
- Disconnect actuator electrical supply plug.
- Unclamp countering nut at limitation screw with wrench SW 10.
- Connect AC voltmeter up to 300 V to AC outlet.
- Ensure no electrical load is switched on.
- Start generator.
- Turn actuator spindle manually until voltmeter reads 270 V.
- Tighten limit stop screw against speed regulator lever.
- Secure with countering nut; check voltage limited to 270 V no load.
Tools required
Tool links are Amazon searches (affiliate links); manufacturer special tools may only be available from a dealer.
Specs & values
- 270 V AC no load
Full service-parts list: Icemaster GmbH (Fischer Panda) Panda PMS 8 mini E-TEC →, Kubota Z482 engine →
Source: Fischer Panda service manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.