Fischer Panda PMS 4200 FCB / Panda PMS 4200 FCB — Starting Generator
Operation
For the Fischer Panda PMS 4200 FCB / Panda PMS 4200 FCB, from the Fischer Panda operator's manual.
Applies to: Fischer Panda Panda PMS 4200 FCB, Farymann 18W430 engine
Before you start
- Do not start generator with load connected.
Procedure
- If necessary, open fuel valve.
- If necessary, close main battery switch.
- Check that all load is switched off.
- Press ON button; Power control light must light up.
- Press START button; starter max 20 seconds, then pause at least 60 seconds.
- Check voltmeter for AC voltage and frequency within tolerance.
- Switch on load only when voltage is within permissible range; connect loads step by step.
Specs & values
- AC voltage tolerance ±3 V without load at nominal voltage
- Generator frequency should be 4% below nominal when running without load
Full service-parts list: Fischer Panda Panda PMS 4200 FCB →
Source: Fischer Panda operator's manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.