Fischer Panda — De-aerating of the coolant circuit / freshwater
Maintenance · cooling system
From a Fischer Panda service manual covering: AGT-DC 10000, AGT10.000-24, PMS AGT-DC 10000, Panda PMS AGT-DC 10000. Check it applies to your exact model before use.
Applies to: Fischer Panda AGT-DC 10000, Fischer Panda Panda PMS AGT-DC 10000, Kubota D722 engine
Before you start
- Generator must be stagnant before opening de-aerating points.
- Do not open cooling water pump de-aerating screw while generator runs.
Procedure
- Open de-aerating screw at cooling water pump.
- Open de-aerating screw at thermostat housing.
- Fill cooling water at filler neck until level stops falling.
- Close filler cap and de-aerating screws.
- Start generator and run for max. 60 seconds.
- Stop generator and repeat procedure several times.
Full service-parts list: Fischer Panda AGT-DC 10000 →, Fischer Panda Panda PMS AGT-DC 10000 →, Kubota D722 engine →
Source: Fischer Panda service manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.