Fischer Panda 4000s SC / Panda 4K PMS — Replacement of the impeller
Maintenance · raw water pump
For the Fischer Panda 4000s SC / Panda 4K PMS, from the Fischer Panda owner's manual.
Applies to: Fischer Panda 4000s SC, Fischer Panda Panda 4K PMS, Kubota Z482 engine
Procedure
- Close the raw water stop cock.
- Remove the cover of the raw water pump by loosening the screws.
- Pull the impeller from the shaft with multigrip pliers; mark its position.
- Check impeller for damage and replace if necessary.
- Lubricate new impeller with glycerin or non-mineral oil based lubricant.
- Fit impeller on the pump shaft in the marked position.
- Fasten the cover and use a new seal.
Tools required
- multigrip pliers Amazon
Tool links are Amazon searches (affiliate links); manufacturer special tools may only be available from a dealer.
Full service-parts list: Fischer Panda 4000s SC →, Fischer Panda Panda 4K PMS →, Kubota Z482 engine →
Source: Fischer Panda owner's manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.