Fischer Panda 3.5e / PMS 5.5e — Long Term and Winter Storage
Maintenance · Generator
For the Fischer Panda 3.5e / PMS 5.5e, from the Fischer Panda operator's manual.
Applies to: Fischer Panda PMS 5.5e
Before you start
- Observe local regulations for the disposal of antifreeze.
Procedure
- Add the correct amount of diesel stabilizer to the fuel tank.
- Check engine coolant mixture for the lowest temperature expected.
- Run generator 15 minutes with fresh water, then 5 minutes with non-toxic anti-freeze.
- Remove impeller to completely drain water; replace with a new impeller.
- Change engine oil and filter; change fuel filters.
- Charge batteries and disconnect; fill diesel tank to prevent condensation.
- Close all generator seacocks; apply low-tack duct tape to intake hose and exhaust outlet.
- Drain raw water system if below freezing; clean and dry any moisture in the capsule.
Tools required
Tool links are Amazon searches (affiliate links); manufacturer special tools may only be available from a dealer.
Specs & values
- Stored greater than 3 months or below freezing temperatures
Full service-parts list: Fischer Panda PMS 5.5e →
Source: Fischer Panda operator's manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.