Home›Repair guides›Fischer Panda›Engine Oil Changing

Fischer Panda 3.5e / PMS 5.5e — Engine Oil Changing

Maintenance · Engine lubrication

For the Fischer Panda 3.5e / PMS 5.5e, from the Fischer Panda operator's manual.

Applies to: Fischer Panda PMS 5.5e

Before you start

  • Spilled oil could result in fire. Clean up any spilled oil immediately.
  • Used engine oil contains products known to cause cancer per California Proposition 65.

Procedure

  1. Run generator under load until normal operating temperature.
  2. Remove load, shut off generator, disconnect starter battery.
  3. Remove oil cap and the cap on the oil drain hose at the service side.
  4. Drain oil completely; a pump may be hooked to the hose if convenient.
  5. Once completely drained, replace oil drain hose cap.
  6. Refill engine oil to the maximum mark on the dipstick.
  7. Do not overfill or underfill; dispose of used oil per local regulations.

Tools required

Tool links are Amazon searches (affiliate links); manufacturer special tools may only be available from a dealer.

Specs & values

  • Oil capacity 2.5 Liters (2.6 Quart)
  • Fill to maximum dipstick mark

Full service-parts list: Fischer Panda PMS 5.5e →

Source: Fischer Panda operator's manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.

More Fischer Panda repair guides →