Cummins/Onan — Wheel Kit Assembly Instructions
Installation
From a Cummins/Onan operator's manual covering: EGMBT/P4500, EGMBU/P5000e, P5000E. Check it applies to your exact model before use.
Applies to: Cummins/Onan EGMBT (P4500) engine, Cummins/Onan EGMBU (P5000e) engine
Before you start
- Do not turn the generator set on the side, top, or end.
- Do not place items on top of the generator set.
Procedure
- Install the handle assembly with two long bolts; do not crush the frame tube.
- Block up the generator set under both frame tubes and under the exhaust-end cross-member.
- Install a leg assembly on each side of the exhaust end cross-member.
- Remove rubber pads; install the wheels with the long hub to the inside.
- Reinstall the washers and cotter pins on the axle; bend one leg of each cotter pin.
- Place axle assembly under the cross member, install four bolts and nuts, tighten securely.
Tools required
- 10 and 12 mm wrenches, sockets, and ratchet Amazon
- Three 6-inch high blocks of wood Amazon
- Pliers Amazon
Tool links are Amazon searches (affiliate links); manufacturer special tools may only be available from a dealer.
Source: Cummins/Onan operator's manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.