Cummins/Onan — Starting from Remote Location (Auto Mode)
Operation · PowerCommand 2.3 control
From a Cummins/Onan operator's manual — check it applies to your exact model before use.
Applies to: Cummins/Onan DFEJ, Cummins/Onan DFEK, Cummins/Onan QSX15-G9 engine
Before you start
- Generator set can start without warning; make sure there is no danger to personnel or equipment.
- With load above 10% and cooldown timer at zero, removing remote start does not stop a single (non-parallel) unit.
Procedure
- Select the Auto button on the operator panel.
- Control receives remote start signal and lights the Remote Start LED.
- After Time Delay to Start, control initiates the starting sequence.
- To disable Auto mode, change to Manual or Off mode.
Specs & values
- Time Delay to Start 0-300 seconds
- Time Delay to Stop 0-600 seconds
Full service-parts list: Cummins/Onan DFEJ →, Cummins/Onan DFEK →
Source: Cummins/Onan operator's manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.