Cummins/Onan — Starting at Operator Panel (Manual Run Mode)
Operation · Operator panel / generator set
From a Cummins/Onan operator's manual — check it applies to your exact model before use.
Applies to: Cummins/Onan DQFAA, Cummins/Onan DQFAB, Cummins/Onan DQFAC, Cummins/Onan DQFAD, Cummins/Onan QST30-G5 engine
Before you start
- Make sure all Pre-start Checks are carried out before starting. Warn all others in the vicinity that the generator set is about to start.
Procedure
- Make sure the main circuit breaker is in the open position.
- Press the Manual button, then press the Start button within ten seconds.
- Allow the engine to warm up and reach the rated speed and voltage.
- Close the main circuit breaker and apply load as required.
Specs & values
- Start button must be pressed within ten seconds of the Manual button
Full service-parts list: Cummins/Onan DQFAA →, Cummins/Onan DQFAB →, Cummins/Onan DQFAC →, Cummins/Onan DQFAD →
Source: Cummins/Onan operator's manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.