Cummins/Onan — See the Installation Manual for important recom-

For these Cummins/Onan models: BGE, Emerald Plus, NHE, Spec N.

Applies to: Cummins Onan Bge, Cummins Onan Emerald Plus, Cummins Onan Nhe, Cummins Onan Spec N

Procedure

1. 6 requires a// persons handhg LPG to be
2. Close the gas shutoff valve(s) at the LPG con-
3. Remove the 1/8 inch pipe plug from the regula-
4. Open the LPG container shutoff valve and try
5. While the genset is running, check the ma-
6. If the genset will not start, jumper the fuel sole-
7. If the genset is operable, check LPG supply
8. Disconnect any jumpers which may have been
9. Continue with the test setup for adjusting LPG
10. 'T' in two hoses to the end of the hose con-
11. Disconnect the hose to the carburetor and at-
12. If the genset is mounted in a compartment,
13. Reconnect the hose to the carburetor, discon-
14. Insert this Supplement in its entirety under
15. On Page 2-2 replace Figure 2-1 with Figure S-1
16. On Page 7-5 replace Figure 7-3a with Figure
17. Insert attached Page A-11 after Appendix A
18. Do not discard Supplement 965-1060,
19. Look for statement “BGE Spec F through K,
20. On Page 6-14, Step 6, change“12.6 and 15.4k

Source: manual:965-0528 Onan BGE (spec F-K) NHE (spec E-K) Genset Service manual (09-1994) 965-1060 Supplement (spec M) (11-1995).pdf. Figures and steps are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.