Specifications
| Fuel | Gasoline, Propane |
|---|---|
| Frequency | 50.0 Hz |
| Standby power | 4 kW |
| Controller | Electronically Regulated |
| Oil capacity | 3.5 L |
| Alternator | Cummins/Onan four-pole |
| Voltage options | 120 V, 240 V |
| Phase | 1-Phase |
| Rated current | 54.2 A |
| Circuit breaker | [120, 124] A |
| Battery cranking | 360 CCA |
| Battery voltage | 12 V |
| Battery quantity | 360 |
| Coolant capacity | [{'value': 0.4, 'unit': 'gal/hr'}, {'value': 1.5, 'unit': 'Uhr'}] L |
| Dimensions (L×W×H) | 635×478×356 mm |
| Dry weight | 97 kg |
| Sound level | 1800.0 dBA |
| Tank runtime | [{'value': 0.4, 'unit': 'gal/hr'}, {'value': 0.7, 'unit': 'gal/hr'}, {'value': 1.3, 'unit': 'gal/hr'}] hr |
Maintenance & consumables
| Item | Spec | Capacity | Part # | Interval | |
|---|---|---|---|---|---|
| Air filter | — | 500 hr | find | ||
| Fuel filter | — | 1000 hr | find | ||
| Oil filter | — | 1000 hr | find | ||
| Belt | — | 500 hr | find | ||
| Coolant | — | 1000 hr | |||
| Coolant filter | — | find | |||
| Hydraulic filter | — | find | |||
| Oil | 3.5 l | — | 50 hr |
Common questions
What is the power rating of the Cummins/Onan NHE?
The Cummins/Onan NHE is rated 4 kW standby.
What fuel does the Cummins/Onan NHE use?
The Cummins/Onan NHE runs on Gasoline, Propane.
What alternator does the Cummins/Onan NHE use?
The Cummins/Onan NHE uses a Cummins/Onan four-pole alternator.
Troubleshooting
20Symptoms & remedies
| Symptom | Cause | Remedy |
|---|---|---|
| Disconnecting Set from RV Systems | 1. First disconnect the negative (-) battery cable from the baitery and then disconnect the battery cables from the genset. 2. Disconnect the remote control wiring harness connector at the genset. 3. Disconnect the generator output wiring and conduit from the power distribution panel or box on the vehicle. Tag all wires to make reconnections easier. 4. Disconnect the exhaust tailpipe from the outlet of the muffler and then remove the muffler. See EXHAUST SYSTEM under Engine Subsystems. 5. Disconnect the fuel line from the genset. Follow the applicable instructions depending on the fuel. | |
| FAILS TO CRANK | 1. Low battery 2. Bad battery connection 3. Blown fuse. | |
| CRANKS SLOWLY | 1. Low battery. | 1. Check battery electrolyte level. 2. Clean and tighten all battery and cable connections. |
| CRANKS BUT WON’T START | 1. Fuel below genset pick-up level 2. Fuel supply shutoff valve closed. 3. Carbon deposits on spark plugs. 4. Blown fuel pump/in tank. | 1. Add fuel. 2. Fully open fuel supply valve. 3. Remove spark plugs and clean. 4. Replace fuse with same type and rating. If problem persists, see Onan service center. |
| EXHAUSTING BLACK SMOKE | 1. Rich fuel mixture. 2. Dirty air filter. 3. Choke stuck. | 1. Turn main fuel adjustment in 1/8 turn (location of adjustment is shown in Figure 3-1). 2. Replace air filter. 3. Contact an Onan service center. |
| UNIT RUNS THEN STOPS | 1. Out of fuel. 2. Low oil level. 3. Excess oil. | 1. Refill fuel tank. 2. Add oil if necessary. 3. Reduce engine oil level. |
| UNIT RUNS BUT SURGES | 1. Loose or worn spark plug leads at spark plugs and ignition coil. 2. Ignition coil, wiring, or control components defective. 3. Faulty spark plugs. 4. Governor out of adjustment. | 1. Check security of spark plug leads at spark plugs and ignition coil. Replace leads if worn. 2. Contact an Onan representative. 3. Remove and clean or replace faulty spark plugs. 4. Contact an Onan service center. |
| The engine fails to crank. | A. Try starting at the genset rather than at the remote control. b. Replace fuse F1 on the control panel if it has blown. c. Clean and tighten the positive (+) and negative (- ) battery cable connections at the battery and the genset. d. Recharge the battery. Refer to the battery manufacturer’s recommendations. | |
| The engine cranks slowly. | A. Disconnect the air conditioner and other large loads. b. Clean and tighten the positive (+) and negative (- ) battery cable connections at the battery and the genset. c. Recharge the battery. Refer to the battery manufacturer’s recommendations. d. Change the engine oil to oil having the proper viscosity for the ambient temperature. See Table 1. | |
| The engine cranks but fails to start. | A. Check the fuel tank and fill if necessary. b. Open any closed fuel shut off valve. c. Check engine oil level and add oil as necessary. d. Replace fuse F2 (side of control panel) if it has blown. e. Service the air cleaner. f. Secure the spark plug leads on the spark plugs. g. Replace the spark plugs. | |
| The engine runs and then stops or surges. | A. Check the fuel tank and fill if necessary. b. Check the engine oil level and add oil as necessary. Drain excess oil if the level is above the dipstick Full mark. c. Check and reset the carburetor preheater lever and altitude adjust knob. See Varying Operating Conditions. (Gasoline models only.) d. Secure the spark plug leads on the spark plugs. e. Replace the spark plugs. | |
| The genset keeps stalling or the circuit breaker keeps tripping. | A. Try running with fewer appliances connected. See Powering Equipment. b. Check the fuel tank (LPG, vapor-withdrawal models) and fill as necessary. On cold days the LPG container may have to be kept at least half full to provide the rate of vaporization necessary to keep up with the genset fuel demand. | |
| There is no electrical power even though the genset runs. | A. Reset tripped circuit breakers. See Powering Equipment. b. Unless there is an automatic power transfer switch, plug the vehicle power cord into the genset power output receptacle (if so equipped) or turn the vehicle power selector switch to its genset position (if so equipped). | |
| The remote battery condition meter indicates low voltage. | A. Clean and tighten the positive (+) and negative (- ) battery cable connections at the battery and the genset. b. Recharge the battery. Refer to the battery manufacturer’s recommendations. | |
| Black smoke exits the tailpipe. | Service the air cleaner. | |
| Eng Cranks But Will Not Start (Genset) | -01 Check: - Spark plugs - Ignition coil - Ignition module -02 Perform checks in step 01 | |
| Engine Overfueling (Genset) | -01 Check: - Spark plugs - Fuel pressure at carburetor - Vacuum pull−off - Electric choke heater -02 Perform checks in step 01 - Check: - Governor adjustments - Carburetor adjustments -03 Perform checks in step 02 - Check: - Ignition coil - Ignition module | |
| Engine Unstable (Hunts) (Genset) | -01 Check: - Fuel supply - Fuel Lines for leakage - Loose wire connection -02 Perform checks in step 01 - Check: - Governor linkage for binding - Governor adjustments - Carburetor adjustments | |
| Engine Will Not Crank (Genset) | -01 Check: - Low battery voltage - Terminal connection−loose or dirty - Battery cable size - Starter drive engagement -02 Perform checks in step 01 - Check: - Remote control - Connections on PCB control board - Start solenoid - Starter | |
| High/Low AC Output (Genset) | -01 Check: - Broken or loose wires - Voltage regulator - Transformer regulator - Engine speed - Voltage ad |
Fault codes and symptom→remedy steps extracted from this model’s service/owner documentation; verify against the official manual before servicing.
Parts
14| Part # | Description | Qty | System | |
|---|---|---|---|---|
| 940-0618 | F Battery | 1 | Battery | PartsGeek |
| 940-0628 | OE-125 Spark Plug | 1 | Spark plug | PartsGeek |
| 940-0636 | V-belt, 1.5 inches wide | 1 | Belt | PartsGeek |
| 940-0637 | OE-103 Coolant | 1 | Coolant | PartsGeek |
| 940-0638 | OE-100 Oil Filter | 1 | Oil filter | PartsGeek |
| 940-0639 | OE-107 Fuel Filter | 1 | Fuel filter | PartsGeek |
| 940-0640 | OE-108 Air Filter | 1 | Air filter | PartsGeek |
| 965-0248 | BATTERY | 1 | Battery | PartsGeek |
| 965-0373 | SPARK PLUG | 1 | Spark plug | PartsGeek |
| M-1604-9 | Spark Plug (Gasoline) | 1 | Spark plug | PartsGeek |
| 323-1486 | Sockets | Service part / kit | PartsGeek | |
| 323-1487-04 | Onan 16-Socket Connector | Service part / kit | PartsGeek | |
| M-1600-3 | PLACE FLOOR TRAY UNDER DRIP TRAY REINFORCEMENT RIBS | Service part / kit | PartsGeek | |
| M-1604-14 | Governor Adjustment | 1 | Service part / kit | PartsGeek |
Service, wear & replacement parts referenced for this model and its engine — confirm the exact part for your serial number. See the full parts catalog to search and cross-reference.
Fuel consumption
| Rating | Load | L/h | gal/h |
|---|---|---|---|
| Prime | 1.2 | 0.3 | |
| Standby | 1.2 | 0.3 | |
| Standby | 1.1 | 0.3 | |
| Standby | 50% | 1.9 | 0.5 |
| Standby | 100% | 3.0 | 0.8 |
Available documents
Operator's manual — 965-0176 Onan BGE NHE RV Genset Operator's manual (07-1997) (Cummins/Onan)Parts manual — DK-Kohler (Cummins/Onan)Service manual — 900-0603 Onan BGE NHE Repair Times (Cummins/Onan)Service manual — 965-0528 Onan BGE (spec F-K) NHE (spec E-K) Emerald Plus series RV Genset Service Manual (09-1994) (Cummins/Onan)Service manual — 965-0528 Onan BGE (spec F-K) NHE (spec E-K) Genset Service manual (09-1994) 965-1060 Supplement (spec M) (11-1995) (Cummins/Onan)spec_sheet — 965-0628 Onan BGE NHE Emerald Plus series RV Genset Installation manual (10-1996) (Cummins/Onan)