Cummins/Onan — Replacing the Brush Block
Repair & overhaul · generator brushes
From a Cummins/Onan service manual covering: 5.5 HGJAA, 5.5 HGJAB, 5.5 HGJAC, 5.5 HGJAD, 5.5 HGJAE, 5.5 HGJAF, 7.0 HGJAA, 7.0 HGJAB, 7.0 HGJAC, 7.0 HGJAD, 7.0 HGJAE, 7.0 HGJAF. Check it applies to your exact model before use.
Applies to: Cummins/Onan 5.5 HGJAD, Cummins/Onan 5.5 HGJAE, Cummins/Onan 7.0 HGJAD, Cummins/Onan 7.0 HGJAE
Procedure
- Disconnect field leads from brush block.
- Remove mounting screw and withdraw brush block from end bell.
- Replace assembly if either brush is shorter than 7/16 inch (11 mm) or damaged.
- Reconnect F- to top terminal and F+ to bottom terminal.
- Make sure leads pass through the lead clip.
Specs & values
- Brush minimum length 7/16 inch (11 mm)
Full service-parts list: Cummins/Onan 5.5 HGJAD →, Cummins/Onan 5.5 HGJAE →, Cummins/Onan 7.0 HGJAD →, Cummins/Onan 7.0 HGJAE →
Source: Cummins/Onan service manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.