Cummins/Onan PCC 3100 — To Service the Air Cleaner
Maintenance
For the Cummins/Onan PCC 3100, from the Cummins/Onan operator's manual.
Applies to: Cummins/Onan DFHA, Cummins/Onan DFHB, Cummins/Onan DFHC, Cummins/Onan DFHD, Cummins/Onan PCC 3100, Cummins/Onan QST30 engine
Before you start
- Filters should be handled with care to prevent damage. If the filter does become damaged, install recommended replacement part.
Procedure
- Loosen fastener(s) and remove air cleaner housing end cap.
- Remove the air filter element from the filter housing.
- To clean, blow low pressure compressed air (30 psi/207 kPa) through the element from the clean side. Hold the nozzle at least 1 inch (25 mm) away to avoid damaging the element.
- Soak the filter for at least 15 minutes in water and Donaldsons D1400 solvent (or equivalent other cleaning solvent) to remove soot and carbon as well as dirt.
- Rinse with clean water (low pressure) and allow to air dry. Do not blow dry. Reinstall when dry. Replace the filter after two cleanings to avoid restricting airflow.
Tools required
- Low pressure compressed air Amazon
Tool links are Amazon searches (affiliate links); manufacturer special tools may only be available from a dealer.
Specs & values
- 30 psi/207 kPa compressed air
- Nozzle held at least 1 inch (25 mm) away
- Soak at least 15 minutes in water and Donaldsons D1400 Amazon eBay FridayParts $48.99 solvent
Full service-parts list: Cummins/Onan DFHA →, Cummins/Onan DFHB →, Cummins/Onan DFHC →, Cummins/Onan DFHD →, Cummins/Onan PCC 3100 →
Source: Cummins/Onan operator's manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.