Cummins/Onan NTA855 — Air Cleaner Service
Maintenance
For the Cummins/Onan NTA855, from the Cummins/Onan operator's manual.
Applies to: Cummins/Onan DFBF, Cummins/Onan DFCB, Cummins/Onan DFCC, Cummins/Onan DFCE, Cummins/Onan DQBA, Cummins/Onan DQBB, Cummins/Onan NTA855, Cummins/Onan NT855 engine, Cummins/Onan NTA855 engine, Cummins/Onan N14 engine
Before you start
- Filters should be handled with care to prevent damage. If damaged, install recommended replacement part.
Procedure
- Loosen fastener(s) and remove air cleaner housing end cap.
- Remove the air filter element from the filter housing.
- Blow low pressure compressed air (30 psi/207 kPa) through element from the clean side.
- Hold nozzle at least 1 inch (25 mm) away to avoid damaging the element.
- Soak filter at least 15 minutes in water and Donaldsons D1400 solvent or equivalent.
- Rinse with clean low pressure water and allow to air dry. Do not blow dry.
- Reinstall when dry. Replace the filter after two cleanings.
Tools required
Tool links are Amazon searches (affiliate links); manufacturer special tools may only be available from a dealer.
Specs & values
- Compressed air 30 psi/207 kPa
- Nozzle at least 1 inch (25 mm) from element
Full service-parts list: Cummins/Onan DFBF →, Cummins/Onan DFCC →, Cummins/Onan DFCE →, Cummins/Onan DQBA →, Cummins/Onan DQBB →
Source: Cummins/Onan operator's manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.