Cummins/Onan — Magneto installation
Installation
From a Cummins/Onan owner's manual covering: 10CW-150R, LOCW-150 R/, LOCW-3R/12 F. Check it applies to your exact model before use.
Applies to: Cummins/Onan 10CW-150R, Cummins/Onan Spec A, Cummins/Onan Spec B, Cummins/Onan Spec C, Cummins/Onan Spec D, Cummins/Onan Spec E, Cummins/Onan Spec F, Cummins/Onan Spec G
Before you start
- Do not change setting as gears mesh.
Procedure
- Turn flywheel until chisel mark 8-1/2 inches before TC is visible through timing hole.
- Hold magneto and turn its drive gear clockwise until gear locks.
- Without changing setting, install magneto to engine so gears mesh.
- Check timing as previously described.
Specs & values
- 8-1/2 inches before TC
Full service-parts list: Cummins/Onan 10CW-150R →, Cummins/Onan Spec A →, Cummins/Onan Spec B →, Cummins/Onan Spec C →, Cummins/Onan Spec D →, Cummins/Onan Spec E →, Cummins/Onan Spec F →, Cummins/Onan Spec G →
Source: Cummins/Onan owner's manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.