Cummins/Onan — Initial Starting and Checks
Operation · Generator set
From a Cummins/Onan service manual — check it applies to your exact model before use.
Applies to: Cummins/Onan MDKAL, Kubota D1005 engine
Before you start
- Exhaust gas is deadly; shut down immediately if an exhaust leak or repair is needed.
Procedure
- Make sure fuel shutoff valve and sea water cock are open and pump is primed.
- Hold Start/Stop switch in Start (use Preheat if needed); set should start within a few seconds.
- Check water flow at hull exhaust outlet.
- Check exhaust system for leaks visually and audibly.
- Check for fuel, oil and coolant leaks; repair before further checks.
- Connect AC voltmeter and frequency meter across two line terminals; verify frequency then voltage.
Tools required
Tool links are Amazon searches (affiliate links); manufacturer special tools may only be available from a dealer.
Full service-parts list: Cummins/Onan MDKAL →, Kubota D1005 engine →
Source: Cummins/Onan service manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.