Cummins/Onan G1250s / M-1902s — Connecting to Vehicle Systems
Installation
For the Cummins/Onan G1250s / M-1902s, from the Cummins/Onan service manual.
Applies to: Cummins/Onan HDKA, Kubota V1305-B engine
Before you start
- Do not connect the battery cables to the genset starting battery until instructed in the Initial Start and Checks section.
Procedure
- Route the fuel line separate from electrical wires or separate them with conduit or sheathing.
- Use fuel hose fittings with 1/8-27 NPT female connectors for the fuel tank pickup and return line.
- Connect the fuel lines to bulkhead connectors at the compartment.
- Install a listed 1/2-inch flexible watertight conduit over the AC wiring.
- Route the battery positive (+) cable through an access hole and connect to B+ on the start solenoid.
- Connect the battery negative (-) cable to a hole in the engine block.
- Route the remote control connector through an opening and connect it to the DC control box.
Specs & values
- Secure fuel line every 18 inches
Full service-parts list: Cummins/Onan HDKA →, Kubota V1305-B engine →
Source: Cummins/Onan service manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.