Cummins/Onan — The armature can now be

For these Cummins/Onan models: CCK, CCK/CCKA, CCKA.

Applies to: Cummins Onan Cck

Procedure

1. Solenoid Starter Only: The armature can now be removed from the front bracket. Be careful not to miss the small steel washer used in the end of the armature shaft. Remove the shift lever at the same time the armature is removed. The spring holder, lever springs and retainercan be removed priorto the lever (Figure 36).
2. Solenoid Starter Only: Remove the ring after driving the pinion stopper toward the pinion gear using a cylindrical tool (Figure 37). Remove the overrunning clutch and the pinion stopper at the same time.
3. Gear Drive Starter Only: The entire assembly is mounted on the armature shaft. When dis- assembling the starter, pay particular attention to the various parts and their positioning in the starter assembly (Figure 38). If the gears of the pinion are damaged, replace the entire pinion. Inspect the screw shaft for rust and burrs.
4. Remove the brushes from the brushholder and inspect them (inspection of brushes and brush springs discussed later).
5. Remove the pole shoes if necessary by removing the flathead machine screws which anchor them to the frame. SOLENOID-SWI TCH

Source: manual:927-0753 Onan CCK CCKA Industrial Engines Service Manual (10-1978).pdf. Figures and steps are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.