Cummins/Onan — Tag each

For these Cummins/Onan models: CCK, CCK/CCKA, CCKA.

Applies to: Cummins Onan Cck

Procedure

1. Remove all wires to the starting unit. Tag each wire so it can be reconnected as originally.
2. Remove the solenoid (where applicable).
3. Remove the starter motor thru-bolts and divide the starter into three main assemblies — the front bracket, the housing and the rear bracket. On some model starters, short screws are used to hold the three starter sections together (Figure

Source: manual:927-0753 Onan CCK CCKA Industrial Engines Service Manual (10-1978).pdf. Figures and steps are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.