Cummins/Onan 80MDKAL11454B — Oil Filter Change
Maintenance
For the Cummins/Onan 80MDKAL11454B, from the Cummins/Onan operator's manual.
Applies to: Cummins/Onan MDKAL, Kubota D1005 engine
Before you start
- Do not overtighten the filter.
Parts for this job
- 7665025430 Oil filter — Cummins/Onan MDKAL Amazon eBay $22.12 PartsGeek $7.98 NAPA $13.30
- 7665025430 Oil filter — Kubota D1005 engine Amazon eBay $22.12 PartsGeek $7.98 NAPA $13.30
Part numbers from the service-parts lists for Cummins/Onan MDKAL, Kubota D1005 engine. Verify against your serial number before ordering; some links are affiliate links.
Procedure
- Place a container under the oil filter to catch dripping oil.
- Spin off the oil filter and discard it properly.
- Thoroughly clean the filter mounting surface.
- Apply a thin film of oil to the filter gasket and spin the filter on until the gasket just touches the mounting pad.
- Turn an additional 3/4 turn; do not overtighten.
- Add the specified quantity of oil to the crankcase, start the set and check for leakage around the filter gasket.
- Tighten the filter only enough to eliminate leaks; shut off the set, recheck oil level and add oil if necessary.
Specs & values
- Turn an additional 3/4 turn after gasket contact
Full service-parts list: Cummins/Onan MDKAL →, Kubota D1005 engine →
Source: Cummins/Onan operator's manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.