Caterpillar — Starting the Engine (EMCP 3)
Operation · Generator set
From a Caterpillar operator's manual covering: C27, C32, SXC1-Up. Check it applies to your exact model before use.
Applies to: Caterpillar C32, Caterpillar C27 engine, Caterpillar C32 engine
Procedure
- Start by pressing RUN key, or with control in AUTO when remote initiate contact becomes active, or via RS-485 SCADA data link.
- EMCP 3 checks that no system faults are present and previous shutdown faults are reset.
- EMCP 3 checks that the engine is not already running and prelube (if equipped) is complete.
- EMCP 3 begins the crank cycle and cranks until total crank time setpoint or until the engine starts.
- EMCP 3 deactivates the starting motor relay when crank terminate speed is reached.
Full service-parts list: Caterpillar C32 →
Source: Caterpillar operator's manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.