Caterpillar — Manual Starting (EMCP II and EMCP II+)
Operation · Engine control switch
From a Caterpillar owner's manual covering: 3456, C1G1-Up, C2T1-Up, C3G1-Up, C4G1-Up, SR4B. Check it applies to your exact model before use.
Applies to: Caterpillar SR4B
Before you start
- Engine exhaust contains products of combustion
Procedure
- Perform Before Starting Engine procedures.
- Turn engine control switch to MAN. START position.
- If engine fails to start within 30 seconds, release starter and wait two minutes.
- Allow engine to warm up.
- Check for fluid or air leaks at idle and half load.
- Operate at low idle until systems reach operating temperature.
Specs & values
- Do not engage starting motor when flywheel is turning
Full service-parts list: Caterpillar SR4B →
Source: Caterpillar owner's manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.