Caterpillar C27 / C32 — Hoses and Clamps - Inspect/Replace
Maintenance
For the Caterpillar C27 / C32, from the Caterpillar owner's manual.
Applies to: Caterpillar C32
Before you start
- Pressurized System: Hot coolant can cause serious burns.
- Do not bend or strike high pressure lines.
Procedure
- Inspect all hoses for leaks caused by cracking, softness, and loose clamps.
- Replace hoses that are cracked or soft; tighten any loose clamps.
- Stop the engine and allow the engine to cool.
- Loosen the cooling system filler cap slowly to relieve pressure; remove the cap.
- Drain the coolant to a level below the hose that is being replaced.
- Remove the hose clamps.
- Disconnect the old hose and replace with a new hose.
- Install the hose clamps with a torque wrench, per Specifications SENR3130.
- Refill the cooling system.
- Clean and inspect the filler cap gaskets; replace the cap if gaskets are damaged. Install the cap.
- Start the engine and inspect the cooling system for leaks.
Tools required
- Torque wrench Amazon
Tool links are Amazon searches (affiliate links); manufacturer special tools may only be available from a dealer.
Full service-parts list: Caterpillar C32 →
Source: Caterpillar owner's manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.