Caterpillar 3054C — Hoses and Clamps - Inspect/Replace
Maintenance
For the Caterpillar 3054C, from the Caterpillar owner's manual.
Applies to: Caterpillar 3054C engine
Before you start
- Pressurized system: hot coolant can cause serious burns.
- Do not bend or strike high pressure lines.
Procedure
- Inspect all hoses for leaks, cracking, softness, and loose clamps.
- Replace hoses that are cracked or soft and tighten any loose clamps.
- Stop the engine, allow it to cool, loosen the filler cap, and remove it.
- Drain the coolant to a level below the hose that is being replaced.
- Remove the hose clamps and disconnect the old hose.
- Replace the old hose with a new hose.
- Install the hose clamps with a torque wrench.
- Refill the cooling system and install the cooling system filler cap.
- Start the engine and inspect the cooling system for leaks.
Tools required
- torque wrench Amazon
Tool links are Amazon searches (affiliate links); manufacturer special tools may only be available from a dealer.
Full service-parts list: Caterpillar 3054C engine →
Source: Caterpillar owner's manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.