Home›Repair guides›Caterpillar›Fuel System Primary Filter (Water Separator) Element - Replace

Caterpillar 3054C — Fuel System Primary Filter (Water Separator) Element - Replace

Maintenance

For the Caterpillar 3054C, from the Caterpillar owner's manual.

Applies to: Caterpillar 3054C engine

Before you start

  • Fuel leaked or spilled onto hot surfaces or electrical components can cause a fire.

Parts for this job

Part numbers from the service-parts list for Caterpillar 3054C engine. Verify against your serial number before ordering; some links are affiliate links.

Procedure

  1. Turn the fuel supply valve (if equipped) to the OFF position.
  2. Place a container under the water separator and clean its outside.
  3. Open the drain (5) and allow the fluid to drain; tighten the drain by hand only.
  4. Hold the element (2) and remove the screw (1); remove the element and glass bowl (3) and discard the element.
  5. Clean the glass bowl and the bottom cover.
  6. Install a new O ring seal and bottom cover onto the new element; install the assembly on the base.
  7. Install the screw and tighten to 8 N·m (6 lb ft).
  8. Dispose of the fuel safely and open the fuel supply valve.
  9. Prime the fuel system.

Specs & values

  • 8 N·m (6 lb ft) screw

Full service-parts list: Caterpillar 3054C engine →

Source: Caterpillar owner's manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.

More Caterpillar repair guides →