Caterpillar 3054C — Engine Oil and Filter - Change

Maintenance · Engine lubrication system

For the Caterpillar 3054C, from the Caterpillar owner's manual.

Applies to: Caterpillar 3054C engine

Procedure

1. Run the engine to normal operating temperature, then stop the engine.
2. Drain the crankcase oil using the drain valve or by removing the oil drain plug.
3. Clean and install the oil drain plugs; renew the O ring seal if necessary.
4. Remove the oil filter with a 1U-8760 Chain Wrench.
5. Clean the sealing surface of the oil filter head.
6. Apply clean engine oil to the O ring seal on the oil filter.
7. Install the oil filter and tighten by hand.
8. For element-type filters, remove the drain plug and filter bowl, and replace the element and O ring.
9. Tighten the filter bowl to 25 N·m (18 lb ft) and the drain plug to 12 N·m (8 lb ft).
10. Remove the oil filler cap and fill the crankcase.
11. Crank the engine with the fuel OFF to fill the oil filters; do not crank more than 30 seconds.
12. Run the engine at LOW IDLE for two minutes and inspect the oil filter for leaks.
13. Stop the engine and allow the oil to drain back to the sump for ten minutes.
14. Check the oil level between the 'ADD' and 'FULL' marks on the oil level gauge.

Full service-parts list: Caterpillar 3054C engine →

Source: Caterpillar owner's manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.

More Caterpillar repair guides →