Briggs & Stratton — Static Governor Adjustment
Adjustments
From a Briggs & Stratton service manual — check it applies to your exact model before use.
Browse Briggs & Stratton generators & specs →
Before you start
- Before starting or running engine, static adjustment of the governor must be made. Failure to make static adjustments first could result in engine overspeeding causing engine or equipment damage, personal injury and/or property damage.
Procedure
- Install all linkage.
- Loosen governor lever bolt and nut.
- Push on governor lever until throttle is wide open; do not bend governor link or distort lever.
- Hold lever and rotate governor shaft counterclockwise as far as it will go.
- Torque governor lever bolt and nut to 8 Nm (70 in. lbs.).
Tools required
- Torque wrench Amazon
Tool links are Amazon searches (affiliate links); manufacturer special tools may only be available from a dealer.
Specs & values
- Governor lever bolt/nut 8 Nm (70 in. lbs.)
Source: Briggs & Stratton service manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.