Briggs & Stratton — Starting Engine — Rewind (Manual) Starter
Operation
From a Briggs & Stratton owner's manual — check it applies to your exact model before use.
Browse Briggs & Stratton generators & specs →
Before you start
- Rapid retraction of starter cord (kickback) will pull hand and arm toward engine faster than you can let go.
- Do not use pressurized starting fluids.
Procedure
- Check oil level.
- Open fuel shut-off valve (if equipped).
- Move choke control to CHOKE or START.
- Move throttle (if equipped) to FAST. Operate engine with throttle in FAST.
- Push rocker switch (if equipped) to ON or RUN.
- Grasp rope handle. Pull slowly until resistance is felt, then pull rapidly to start engine and avoid kickback.
- Let engine warm up; move choke control lever toward RUN a short distance at a time.
Source: Briggs & Stratton owner's manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.