Briggs & Stratton — Setting the Exercise Timer
Operation · Exercise cycle timer
From a Briggs & Stratton service manual — check it applies to your exact model before use.
Browse Briggs & Stratton generators & specs →
Before you start
- No buttons pressed for 30 seconds will auto-exit program mode.
Procedure
- Choose the desired day and time for exercise cycle.
- Press and hold left and right arrows simultaneously for 3 seconds to enter General Set Up mode.
- Verify or set the time and date on the controller.
- Navigate to SET EXERCISE prompt and press OK.
- Select desired day, then press OK.
- Select desired hour (1-12), then press OK.
- Select desired minutes (00-59), then press OK.
- Select AM or PM, then press OK.
Specs & values
- Default setting: Tuesday at 2:00 PM
- Duration: approximately 20 minutes
- Frequency: once every seven days
- Load transfer: does not occur unless utility power outage
Source: Briggs & Stratton service manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.