Briggs & Stratton — Replacing Solenoid
Repair & overhaul · Starter solenoid
From a Briggs & Stratton service manual — check it applies to your exact model before use.
Browse Briggs & Stratton generators & specs →
Procedure
- Remove nut and field coil wire from stud terminal.
- Remove solenoid mounting nuts and solenoid.
- Lift solenoid to disengage drive lever from plunger — hold starter vertically with drive housing side down.
- Engage flats on plunger with fork in drive lever and assemble solenoid to starter; torque nuts to 8.0 Nm (70 in. lbs.).
- Install field coil wire and nut; torque nut to 10.0 Nm (90 in. lbs.).
- Install starter motor; torque screws to 40.0 Nm (30 ft. lbs.).
Specs & values
- Small hole in rubber dust cover must face starter
Source: Briggs & Stratton service manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.