Briggs & Stratton — Plug in Items to be Powered
Operation · Electrical Output
From a Briggs & Stratton operator's manual — check it applies to your exact model before use.
Browse Briggs & Stratton generators & specs →
Before you start
- Do not connect 240 Volt loads to the 120 Volt receptacles.
- Do not connect 3-phase loads to the generator.
- Do not connect 50 Hz loads to the generator.
- Do not overload the generator.
Procedure
- Make sure the green output indicator light comes on.
- Let engine stabilize and warm up for a few minutes after starting.
- Plug in and turn on desired 120 Volt AC single phase 60 Hz electrical loads.
- Plug items to be powered in sequence as shown.
Source: Briggs & Stratton operator's manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.