Briggs & Stratton — Installing Water Pump

Installation

From a Briggs & Stratton service manual — check it applies to your exact model before use.

Browse Briggs & Stratton generators & specs →

Procedure

1. Install water pump with new gasket; torque screws and nuts to 19.0 Nm (170 in. lbs.).
2. Install coolant inlet with new gasket; torque screws to 7.0 Nm (60 in. lbs.).
3. Install thermostat and coolant outlet with new gasket; torque screws to 7.0 Nm (60 in. lbs.).
4. Install bypass hose and temperature gauge wire (if equipped).
5. Install radiator hoses.
6. Install fan (if equipped) and water pump pulley; torque screws to 7.0 Nm (60 in. lbs.).
7. Install V-belt; belt tension adjustment 10.0-12.0 mm/10 kg (3/8 — 1/2 in/22 lb).
8. Refill cooling system.

Source: Briggs & Stratton service manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.

More Briggs & Stratton repair guides →