Briggs & Stratton — Idle Control Solenoid Adjustment
Adjustments
From a Briggs & Stratton service manual — check it applies to your exact model before use.
Browse Briggs & Stratton generators & specs →
Before you start
- Let engine warm up before adjusting
- Verify governor operation after adjustment
Procedure
- Set the idle control switch to OFF
- Unplug all electrical loads from the generator
- Connect an AC frequency meter to the generator's AC output receptacle
- Crank and start the engine, let stabilize and warm up
- Check frequency meter reading for proper governed speed
- Set idle control switch to ON
- Verify idle control solenoid energizes and engine decelerates to idle
- Check frequency meter reading at idle
- If outside range, loosen solenoid jam nut and turn solenoid to adjust
- Retighten jam nut after adjustment
Tools required
Tool links are Amazon searches (affiliate links); manufacturer special tools may only be available from a dealer.
Specs & values
- Target idle: 40-45 Hz (2100-2400 rpm)
- Target high speed 60 Hz: 61.5-63.5 Hz (3690-3810 rpm)
- Target high speed 50 Hz: 50.5-51.5 Hz (3030-3090 rpm)
Source: Briggs & Stratton service manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.