Briggs & Stratton — Changing Oil Filter (if equipped)

Maintenance

From a Briggs & Stratton owner's manual — check it applies to your exact model before use.

Browse Briggs & Stratton generators & specs →

Procedure

1. Drain engine oil and remove oil filter.
2. Before installing new filter, lightly oil filter gasket with fresh, clean oil.
3. Screw filter on by hand until gasket contacts oil filter adapter. Tighten 1/2 to 3/4 turn more.
4. Add fresh oil. Fill to FULL line on dipstick.
5. Start and run engine at idle to check for leaks.
6. Stop engine. Re-check oil level. Add oil if required.

Source: Briggs & Stratton owner's manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.

More Briggs & Stratton repair guides →