Briggs & Stratton — Change Oil
Maintenance · Lubrication system
From a Briggs & Stratton service manual — check it applies to your exact model before use.
Browse Briggs & Stratton generators & specs →
Procedure
- Remove oil drain plug and drain oil while engine is still warm.
- Check oil drain plug gasket and replace if necessary.
- Install and torque drain plug to 25.0 Nm (220 in. lbs.).
- Remove oil fill cap and refill with oil of recommended grade and viscosity.
- Fill to FULL mark on dipstick. Oil capacity 3.3 liters (3.5 quarts).
Specs & values
- Oil Capacity 3.3 liters (3.5 quarts)
- Drain plug torque 25.0 Nm (220 in. lbs.)
Source: Briggs & Stratton service manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.