Briggs & Stratton — Adjust Governor
Adjustments
From a Briggs & Stratton service manual — check it applies to your exact model before use.
Browse Briggs & Stratton generators & specs →
Procedure
- Move governor control lever up to end of travel and hold in this position (throttle wide open).
- Rotate governor shaft clockwise to end of travel.
- Torque governor nut to 10.0 Nm (90 in. lbs.).
- To check: stop engine, move equipment control to Fast, disconnect governor link spring and link, rotate throttle wide open.
- Governor link must be within 1 mm of center of hole in throttle lever; if greater, perform governor adjustment.
- If engine continues to hunt, decrease sensitivity by moving governor spring to next hole on governor lever (away from pivot decreases sensitivity).
Specs & values
- Governor nut torque 10.0 Nm (90 in. lbs.)
Source: Briggs & Stratton service manual. Steps and values are as documented; always cross-check against the official manual and any later revisions for your exact serial number before servicing.